To make this lamp shade you will require a lamp with top and bottom hoops, lots of pop tabs and pliers. Start by collecting a lot of tabs. Then bend some tabs into half using pliers to come on the top hoop. Once the top hoop is covered with bent tabs start cutting tabs for the rest of the lamp shade. Fix each cut tab between the holes of every upper two tabs. Repeat the same step in rows until you reach the desired size of lampshade. Then in the end bend tabs for the lower hoop. Pass a bent tab from the lower hoop and fix it between the holes of upper two tabs. Keep on doing it until all of the lower hoop is covered and connected to the upper tabs. Fix the bulb in the lamp and there you go. Your pop tab lamp shade is ready. For more details visit makezine.